User Tools

Site Tools


touchbound_system:detcord

This is an old revision of the document!


Detcord Collar

This is a KDC Halloween special, it is only available for sale from October 15th to November 15th

Supported TouchBound functions

Sensing zones

  • The main locking point (the detcord loop) can only be “locked” and “unlocked” with duct tape & cutter, under RLV, it will prevent the collar from being detached.
  • The leashing ring can draw and receive chains to leash handles, anchor points, other restraints, and even restraints worn by others!
  • The igniter pin, while functioning like a regular leashing point, will act as a hair trigger for the detonation function.

Supported locks

Detonation

When chained, the Detcord collar igniter (this doesn't apply to the primary leash point) will act like a hair trigger, if the leash is pulled taut in any way, it will initiate the detcord explosion:

  • Wearer pulls on the igniter chain (or is pulled)
  • Igniter china disconnects.
  • Explosion occurs (particle effect), hiding the wearer for a certain amount of time.
  • If possible (land permissions) a scorch mark will be displayed on the ground.

A few aspects of the KDC Detcord Collar can be adjusted by renaming specific notecards inside the collar's main inventory. All configuration options are case-sensitive.

config.explosion

This configuration flag can be used to completely disable the detonation function, as if the igniter was deactivated or malfunctioning.

  • config.explosion=Yes: (Default) Pulling on the igniter chain will trigger the detonation feature.
  • config.explosion=No: Pulling on the igniter chain will detach the chain connected to it, and nothing else.

config.explosion.respawn

This configuration flag determinates the delay before the avatar “respawns” after detonation.

config.death.effect

This configuration flag can be used to adjust the severity of the “death” effect.

Bondage poses

This table contains all the special poses that the collars can initiate, the source object the the first object that you click in the touch sequence, while the target object is the second object in the sequence.

Some chaining combinations will offer you to add a specific bound poses, if the current avatar limb configuration allows it.

Some poses only use one arm at a time, which allows you to either bind both arms in the same pose, or use a different pose on the remaining arm. Check the corresponding column.

Pose Source object Target object Description & examples single wrist
Tight front Collar front ring Any wrist cuff One hand is tied at the front of the collar. yes
Low front Collar front ring Any wrist cuff Similar to “tight front” but in a lower, more relaxed position. yes
Stooped collar front ring belt front ring The wearer is forced to bend forward. N/A
touchbound_system/detcord.1634288957.txt.gz · Last modified: 2021/10/15 09:09 by kyrahabattoir